Thermostatic
In this style of fan control, the fan is either on or off. A system thermistor checks the temperature inside the chassis, and if it detects a temperature outside of range, it spins the fans up to maximum. When the temperature drops below a threshold again, the fans are turned back off. This control method reduces power requirements during periods of low usage, but when the system is operating at capacity, the fan noise can become a problem again.
Pulse-width modulation
Pulse-width modulation (PWM) is a common method of controlling computer fans. A PWM-capable fan is usually connected to a 4-pin connector (pinout: Ground, +12V, sense, control). The sense pin is used to relay the rotation speed of the fan and the control pin is an open-drain or open-collector output, which requires a pull-up to 5V or 3.3V in the fan. Unlike linear voltage regulation, where the fan voltage is proportional to the speed, the fan is driven with a constant supply voltage; the speed control is performed by the fan based on the control signal.
The control signal is a square wave operating at 25kHz, with the duty cycle determining the fan speed. Typically a fan can be driven between about 30% and 100% of the rated fan speed, using a signal with up to 100% duty cycle. The exact speed behaviour (linear, off until a threshold value, or a minimum speed until a threshold) at low control levels is manufacturer dependent.[3]
The reason I'm interested in these 2 types of fan control is because they are relevant to my project
No comments:
Post a Comment